4
(EN)
Installation Precautions
Installation Location for the Receiver
The wireless remote controllers use a very weak infrared light for its signal, which can result in the
signal not being received because of the following in
fl
uences, so take care in where the unit is installed.
• Inverter or rapid-start type
fl
uorescent lights (Models without glow lamps)
• Plasma display or LCD televisions
• Direct sunlight or other sources of bright light
Mounting
Installing the Receiver
The receiver can be installed only on the
corner shown in Fig. A. Consider the direction
where the panel is attached to the indoor unit.
1
Remove the air inlet grille
Indoor unit electric component box
Installation position for receiver
(Fig. A)
Indoor unit electric
component box
Air Inlet grille
2
Remove the corner cover.
Remove the screw
fi
xing the corner
cover.
Screw
Corner cover
Convex part
Place a hand on both the right and left
convex parts of the corner cover to
remove it.
Corner cover
Ceiling panel
3
Wire the receiver.
Hang the string of the receiver on the pin
of the ceiling panel.
Receiver
Pin
String
Pass the wiring from the wireless
receiver section into the slit.
(See “Wiring for the Receiver”)
Fix the wiring with the clamper (supplied)
while leaving enough length of wiring to
remove the receiver.
• When attaching the
fi
lter chamber, cut
the clamper (a), and attach the receiver.
Slit
Fix with the clamper (supplied).
(a) Cut this clamper.
4
Fix the receiver.
Fit the receiver to the ceiling panel so
the 5 claws are properly set, and
fi
x it
with the removed screw.
• Make sure the wire
is not caught.
• Refer to the
installation
instructions
supplied with the
panel.
Summary of Contents for CZ-RWSU3
Page 10: ... Panasonic Corporation 2016 ...
