EN-8
Setting Up Programmed Operations
Correctly set the present time and today’s day of the week.
Unless both are correctly set, the programs will not run as expected.
Up to 6 programmed operations can be set per day for each group and day
•
of the week.
A combination of the below operations can be set for each timer program.
•
Air conditioner starting/stopping
–
Remote controller operation enable/disable *1
–
To change the settings of an existing program, use the same below
•
procedure used to set up a new program.
*1 The remote controller operation enable/disable setting is disabled
depending on installation conditions. If so,
appears on the display when
the
button is pressed.
For more information, contact your dealer.
Example settings
STEP 1
Press the PROGRAM button to select a group.
When the PROGRAM button is pressed, the group
•
No. and today’s day of the week start blinking and the
present time indication changes to a blinking “PG-1”.
Press the GROUP button to select a group for
•
programmed operation and then press the SET
button.
NOTE
Group selection is disabled depending on installation
•
conditions. If so, proceed to the next step.
The number of selectable groups is set during
•
installation.
STEP 2
Press the DAY button and select a day of the week for
programmed operation.
When the SET button is pressed, the program
•
schedule marker
(
)
changes from blinking to
lighting and, at the same time, the time set in program
starts blinking. Also, the present time indication
changes to a blinking “PG-2”.
NOTE
The currently selected day of the week blinks slowly at
•
this time.
CZ-ESWC2.indb EN-8
CZ-ESWC2.indb EN-8
2011/06/02 10:42:53
2011/06/02 10:42:53
