9
2
• When Wireless LAN LED is blinking, select
the preferred connection setup mode.
Setting connection network (Wired remote controller)
1
• Check that the Wireless LAN LED is ON.
At the remote controller, select the WLAN
ON/ OFF until the Wireless LAN LED starts
blinking.
• Select Function Setup from remote controller
Main Menu.
12:00,Mon
Main menu
Select
Confirm
Function setup
System check
Personal setup
Service contact
(Indoor unit’s Wireless LAN LED)
Fast blink
The unit is establishing the connection.
Slow blink
The unit is not securing the connection.
No blink
(stays on)
The unit has established the connection.
• It can establish the connection to the unit even if the unit is turned OFF.
Note
• If the Wireless LAN LED blinks continuously and you
do not want to use the app, select the WLAN ON/OFF
to turn it off.
*1 The interfaces shown here refers to models with wireless remote controller,
however models with wired remote controller shares the same interfaces and
illustrations. Please refer wired remote controller display selection to perform the
app settings.
*1
12:00,Mon
Function setup
Select
Confirm
Powerful
Quiet
Filter check
WLAN
12:00,Mon
WLAN
Select
Confirm
WLAN ON/OFF
Easy setting (WPS)
Advance setting (AP)
Device registration
12:00,Mon
WLAN ON/OFF
Confirm
Request
(Remote Controller Display)
