2.3. Reassenbly instructions
2.3.1. Attention when CF-Y4H series is repaired
·
Execute writing BIOS ID when you exchange the Main Board.
·
Parts (sheet and rubber) etc. related various the conductive cloth and heat spreader cannot be recycled. Use new parts.
2.3.2. Assembly knowhow of part LCD
LCD Protect Plate
Insert the LCD Protect Plate to down forward while holding a transparent sheet in the back.
(The two sided tape side is the front.)
Put the LCD Dumper (D) on the back of the LCD Protect Plate.
LCD Dumper (D)
Externals
suiting
0~
0.5mm
10~12mm
Putting of the LCD Protect Plate and LCD Dumper (D)
LCD Front Case
LCD Dumper (I)
EMI Sheet
EMI Sheet
LCD Dumper (I)
Match the LCD damper (I)
by rib edge/LCD Panel externals
of the LCD Front case 0.5mm.
Match the LCD Damper (I)
by rib right edge
0.5mm.
Match the LCD Damper (I)
by rib right edge
0.5mm.
EMI Sheet
Match the EMI Sheet to the edge
side of wall of the LCD Front Case.
EMI Sheet
LCD Dumper (I)
LCD Module
LCD Module
LCD Module
LCD Dumper (I)
LCD Gusket
LCD Dumper (I)
LCD Gusket
3~5mm
LCD Dumper (I)
Putting of LCD Damper (I), EMI Sheet and LCD Gasket
3~5mm
2-10
Summary of Contents for CF-Y4 - Batt For
