9-13
9.2.6.
Setting the USB PCB
1. Fix the USB PCB to the computer using the two
Screws<N9>.
2. Connect the USB Cable to the Connector (CN1701).
Screws <N9>: DFHE5025XA
Q
Arranging the USB Cable
<N9>
USB PCB
CN1701
MP Slide Sheet
MP Slide Sheet
USB Cable
Attach the MP Slid Sheet to prevent the Cable from coming off.
A
Fitting edge
Pass the Cable through
the notch and lead it downward.
Fit the surplus length of
the Cable into this side.
Tape
Connect
the Connector.
Pass it through
the notch.
Ensure the Cable does not
come out of the board edge
so that the Cable does not
touch the MP Drive.
Pass it through
the notch.
Avoid runnning over the boss.
Pass it through the rib.
Ensure the "A" end does not come on the level.
Safety Working
Fit the Cable between the pins.