38
Run the Setup Utility
(
page 44
)
1
Using USB Devices
2
3
Using and , select [Power]
4
5
Using and , select [Power Management Mode] and
press Enter
9
Using and , select [Power Switch] and press Enter
Using and , select [Fn+F7/Fn+F10] and press Enter
Install the Windows 95 USB device drivers
CAUTION
After a driver has been installed, do not use the suspend or hibernation func-
tion. If the suspend or hibernation mode is activated, the computer may not
function properly. Power off, then on, using the power switch to resume proper
operation.
If you want to use the suspend or hibernation function when the USB driver is
installed, disable the USB device function of the computer.
(
page 14
)
(To next page)
Using and , select [Off] and press Enter
Using and , select [Off] and press Enter
Using and , select [Disable] and press Enter
Press F10 , then select [Yes]
10
6
7
8
USB Port
Installing USB Devices
1
In [Start] - [Run], input [c:\util\msupdate\usb\usbsupp.exe], then press [OK].
At the confirmation message, press [Yes].
2
Read the [END-USER LICENSING AGREEMENT] and press [Yes] or [No].
• Installation will start if [Yes] is pressed.
• Installation will be aborted if [No] is pressed.
3
At the display indicating the completion of installation, press [OK]. The com-
puter will automatically restart.
4
In [Start] - [Run], input [c:\util\msupdate\usb\usbcopy.bat], then press [OK].
5
Click
at the upper right corner to close the display.
6
In [Start] - [Settings] - [Control Panel] - [System] - [Device Manager], select
[PCI Universal Serial Bus] in [Other devices], press [Remove], then press
[OK].
7
Press [Refresh] and press [Close] at the [System Properties],
8
Restart the computer.
Windows NT
USB devices are not supported.
Windows 95