•
If the camera is connected to a router, you can usually leave this field blank.
4.
Under [Default Gateway], enter the default gateway IP address if required by your ISP or network
administrator.
•
This field can normally be left empty.
5.
Under [DNS], enter the IP addresses of the primary and secondary DNS servers if required by your ISP
or network administrator.
•
These fields can normally be left empty.
6.
Under [Max. Bandwidth Usage], select the maximum bandwidth you want to allow the camera to use.
•
This setting is effective for both IPv4 and IPv6 connections.
•
Refer to the following file size information when restricting the maximum bandwidth. Note that these
are estimated file sizes; the actual file size may vary depending on image quality, image brightness,
etc.
–
192
´
144: 3.5 KB (28 Kbit)
–
320
´
240: 10 KB (80 Kbit)
–
640
´
480: 18 KB (144 Kbit)
7.
Under [Connection Type], select the appropriate connection type.
•
Normally you can leave this setting at [Auto Negotiation].
•
This setting is effective for both IPv4 and IPv6 connections.
•
BL-C131A only:
If using the camera in wireless mode, [Auto Negotiation] must be selected.
8.
Click [Save].
9.
When the [New settings are saved.] message is displayed, click [Restart].
•
All buffered images are deleted when the camera is restarted.
*1
[Space], [“], [’], [&], [<], and [>] cannot be entered.
Note
•
If the camera’s IP address was changed as a result of changing the network settings, use the Setup
Program on the CD-ROM to find the camera’s new IP address (see Page 143).
•
The current network settings can be confirmed on the [Status] page (see Page 119).
86
Operating Instructions
5.1.1 Network (IPv4) Settings
