2.
On the left side of the screen, click [Status].
3.
Under [UPnP], confirm that the status is [Enabled].
•
If [Enabled] is not displayed, refer to the UPnP™ related items in 1.3 Camera Setup Issues and
1.5 Camera Access Issues in the Troubleshooting Guide.
Configuring port forwarding without using UPnP™
If your router does not support UPnP™, you need to configure the router’s port forwarding feature manually.
1.
Click the [Setup] tab.
2.
On the left side of the screen under [Basic], click [Network (IPv4)].
3.
Under [Connection Mode], click [Static].
4.
Make a note of the IP address and port number displayed here. You will need to know these settings when
configuring the router for port forwarding.
5.
Click [Save].
6.
Click [Restart].
7.
While referring to the operating instructions included with your router, configure the router’s port forwarding
feature.
•
When configuring port forwarding, store the camera’s IP address and port number that you noted
above.
8.
Register the camera to use a Dynamic DNS service, such as Viewnetcam.com (see Page 75).
Operating Instructions
73
4.1 Configuring Port Forwarding