5
Installation
4
Secure the unit with the screws.
Use the accessory screws (M4 screws with flat
washers and spring washers).
Provisionally secure the unit with attaching the screws
in numerical order (
1
to
4
).
When it is confirmed that all the four screws have been
set properly, secure the screws firmly.
5
Check again that hook at the end of
the drop-prevention wire is definitely
attached to the installation surface
bracket.
6
Connect the cables.
The screws for preventing cable looseness must be
tightened up securely at the D-sub connector.
The power cable must be secured using the clamps for
preventing looseness.
7
Attach the cable cover.
Fit the two tabs in the cable cover into the holes used
for attaching the rear panel.
Use the two accessory M3 flat head screws to secure
the cover.
8
Adhere the screw concealment sheet in
place.
Adhere the accessory screw concealment sheet so that
the screws are no longer visible.
Screw concealment sheet
The drop-prevention wire has plenty of leeway in its
length so stow the unused part of the wire inside the
cable cover.