Panasonic AWE860N - COLOR CAMERA, Operating Instructions Manual

Page: 102 / 136

-30-
U
Color phase adjustment
Supply the output signal (split color bar) from the color
special effect generator to a color monitor or vectorscope.
Adjust the color phase of the camera.
[ADJUSTMENT by CAMERA or the multi hybrid control
panel]
1. Press the NO/BAR switch for over 5 seconds for the color
bar mode.
2. Select [G/L Adjustment] on the main menu, then select
[SC Coarse] on the sub menu.
3. Make coarse adjustment with the YES/ABC switch and
the NO/BAR switch.
4. Select [SC Fine] on the sub menu. Perform fine
adjustment with the YES/ABC switch and the NO/BAR
switch.
For details on the menu operations using the multi hybrid
control panel, refer to the Operating Instructions of the multi
hybrid control panel.
[ADJUSTMENT with RCU]
Use the subcarrier phase coarse adjustment control and
subcarrier phase fine control.
❈
It is recommended that a vectorscope be used for
maximum accuracy in color phase adjustment.
Caution:
• When color phase adjustment is required using RCU,
color bar/camera selector switch should be set to BAR.
Color phase cannot be adjusted if the switch is in the
CAM position. After adjustment set color bar/camera
selector switch back to CAM.
• When horizontal phase adjustment is moved, color phase
is also moved. Adjust color phase whenever horizontal
phase adjustment is moved.
Color bar of camera
Color bar of special
effects generator
Sprit line