11
Config screen
1
Network
Set the IP address, net mask and gateway address in the fields provided here.
Consult your network administrator for details on the addresses.
After setting the information, you must click the
4
button. Bear in mind that the
settings will not take effect unless this button is clicked.
Refer also to the pages on system upgrading.
2
Default Image setting
Set the quality and size of the image which is to appear when the power is turned ON.
The factory settings are HIGH for the image quality and VGA (640
a
480) for the size.
The settings can be changed on the “Image Control” screen during operation.
3
Password
A three level password can be set here. For details, refer to the page on the passwords.
4
Submit Query
When the settings
1
through
3
have been performed, you must click this button and check that the
settings completed screen has appeared. The settings will be updated about 15 seconds after the
button is clicked.
Bear in mind that the settings will not be updated if the screen is exited without pressing the button.
<Notes>
≥
If the settings on the Config screen are to be updated, you must make a note of these settings.
If the IP address and password cannot be identified when the WEB camera has been installed in a
distant location, it will be difficult to restore the factory settings. In this event, access will be denied.
≥
If the IP address cannot be identified, the factory setting can be restored. Refer to “<Reference>
Resetting method” on page 8.
After resetting, perform the settings again by following the instructions from the beginning.
≥
When the power is turned back on, the statuses set on the Config screen will take effect rather than
the previous statuses even after the image quality or size has been changed on the “Image Control”
screen.
Submit Query
