Panasonic AW-HE40HWP, Operating Instructions Manual

Page: 40 / 64

40
Parts and their functions
(continued)
i
LAN connector for IP control [LAN ACT/LINK]
This LAN connector (RJ-45) is connected when exercising
IP control over the unit from an external device.
Use a cable with the following specifications for the
connection to the LAN connector:
When connecting through a hub:
LAN cable
*
(category 5 or above),
max. 100 meters [328 ft]
When using a PoE+ compatible hub:
LAN cable * (category 5e or above),
max. 100 meters [328 ft]
When a hub is not used:
LAN cable
*
(category 5 or above),
max. 100 meters [328 ft]
*: Use of an STP (shielded twisted pair) cable is
recommended.
j
Anti-theft wire mounting hole
Use this hole to attach the wire bracket (commercially
available).
k
Audio input connector [AUDIO IN]
Inputs external audio (microphone, line).
l
RS-232C connectors [RS-232C IN/OUT]
Connect to RS-232C cables.
RS-232C IN/OUT
connector
1 2
3 4 5
6
7
8
●
Mini DIN 8-pin
(JST)
RS-232C IN RS-232C OUT
Pin
No.
Signal
Pin
No.
Signal
1 DTR_IN 1 DTR_OUT
2 DSR_IN 2 DSR_OUT
3 TXD_IN 3 TXD_OUT
4 GND 4 GND
5 RXD_IN 5 RXD_OUT
6 GND 6 GND
7 IR OUT R 7 NC
8 IR OUT L 8 NC
●
Be aware that the polarities (+/−) of the serial data
may be different depending on the specifications of
the device to be connected.
Note
m
DC IN connector [12V IN ]
Connect the AC adaptor supplied with the unit to this
connector to supply the DC 12 V voltage to the unit.
n
Cable clamp
This is used to hold the cable connection to the DC IN
connector and prevent it from becoming disconnected.
o
Ground connector
Connects to the ground connector on a wall outlet, ground
bar, etc. for grounding. (page 24)
p
RS-422 connector [RS-422]
This RS-422 connector (RJ-45) is connected when
exercising serial control over the unit from an external
device.
Use a cable with the following specifications for the
connection to this connector.
LAN cable * (category 5 or above, straight cable), max.
1000 meters [3280 ft]
*: Use of an STP (shielded twisted pair) cable is
recommended.
The tally lamp can be lit by shorting the TALLY signal (pin
2) with GND (pin 1).
1 8
Pin
No.
Signal
Pin
No.
Signal
1 GND 1 TXD +
2 TALLY 2 RXD +
3 RXD – 3 —
4 TXD – 4 —
●
Do not apply a voltage to the TALLY signal pin.
Note
q
USB port
Used for maintenance.
Do not connect USB devices here.
r
microSD card slot
Used for maintenance.
Do not insert memory cards here.
s
Threaded hole (thread: 1/4-20UNC, ISO1222
[6.35 mm]) for mounting the camera
Use this hole when mounting the camera on a tripod, etc.
t
HDMI connector [HDMI] (AW-HE40H only)
This is the HDMI video signal output connector.
u
SDI OUT connector [SDI OUT]
(AW-HE40S only)
This is the SDI video signal output connector.