8
Mount bracket
(provided)
Screws (provided)
Screws (locally procured)
Cable clamper
(provided)
85 mm
(3-3/8")
127 mm (5")
It is possible to use this charger either by laying on a level
place or mounting on the wall.
1. Insert the DC connector of AC adaptor into the DC jack
of charger.
DC connector
DC cable
Cable ring
Cable tie
(provided)
Preparation/Installation
2. Pass the cable tie through either of the cable rings at the
side of charger, and make a loop with the cable tie.
3. Pass the DC cable through the loop of cable tie, and pull
the end of cable tie to fasten the DC cable to the cable
ring.
4. Plug the AC adaptor into the AC outlet.
■
When Mounting the Charger on the Wall
Important:
Surely clamp the DC cable to this battery charger and
screw the DC cable to the wall using the provided cable
clamper.
1. Secure the provided mount bracket to the rear of charg-
er by fastening the provided screws (x4).
Recommended tightening torque: 0.78 N·m {8k
g
f·cm}
2. Secure the mount bracket to the wall by locally procured
screws (x5).
• Procure 5 mounting screws according to the materi-
al of the installation area.
In this case, wood screws and nails should not be
used.
Recommended screw: M4 x 25 mm
• Required pull-out capacity of a single screw/bolt is
118 N {12 k
g
f} or more.
• If a wall board is too weak to support the total
weight, the area shall be sufficiently reinforced.
