102
Before storing the camera, remove both the
memory card and battery.
Store all of these items in place with low humidity
and relatively constant temperature.
Recommended temperature range: 15°C - 25°C
Recommended relative humidity: 40% - 60%
Camera-recorder
•
Wrap the camera-recorder in a soft cloth to keep
the dust off.
Battery
•
The service life of the battery will be shortened
when exposed to extreme temperatures.
•
Storing the battery in a location with oily vapors
or high dust concentration may result in corrosion
to the terminals or other damage, leading to
malfunction.
•
Keep metal objects (such as necklaces and
hairpins) away from the terminals. Short-
circuiting may occur across the terminals,
causing the battery to heat up, you may
seriously burn yourself if you touch the
battery in this state.
Memory card
•
After ejecting a memory card from the camera-
recoder, always put it in its own case.
•
Do not leave memory cards in areas where
corrosive gases, etc. are present.
•
Do not leave the memory cards inside vehicles,
in places exposed to direct sunlight or in other
places where the temperature is high.
•
Do not leave the memory cards where the
humidity level is high or where there are high
concentrations of dust.
Cleaning
When cleaning, do not use benzene or thinner.
•
Benzene or paint thinners may deform the camera
body and/or cause the surface finish to peel.
•
Before proceeding with maintenance, remove the
battery or disconnect the AC cord from the power
outlet.
•
Wipe the camera-recorder with a soft, clean cloth.
To remove stubborn dirt, wipe the camera with a
cloth moistened with kitchen detergent diluted in
water and then finish with a dry cloth.
Eye cup holder
Eye cup
Ridges
Cleaning the viewfinder
If there is dust in the viewfinder, remove the eye cup
holder and get rid of the dust.
•
The interior of the eye cup holder is specially
finished, so do not wipe it under any circumstances.
If dust has adhered, blow it off with an air blower.
•
Remove the eye cup holder by rotating
counterclockwise with the eye cup attached.
(It has been tightly screwed on.)
When you do this, tilt the viewfinder slightly upward.
•
To mount the eye cup holder, align the ridges
and grooves of the eye cup holder and camera-
recorder, and turn clockwise until the holder clicks
into place.
Turn counterclockwise
to remove it.
Storage precautions
