Panametrics C-ET, Installation Manual

Page: 23 / 50

Model C-ET Installation Guide 15
1.3.3.2 Setting the Transducer Spacing
1. If necessary, assemble the fixture as shown below. Make sure the zero points on each ruler are at the same end of
the fixture as shown below.
2. Using a ruler (or the ruler printed on the fixture), set one of the mounting blocks at least 2 in. (5 cm) from the edge
of the fixture. To move the block, loosen the set screw, slide the block to the desired location and tighten the set
screw. Use the edge of the block shown below as the setting point.
Zero Point on
Measuring Scales
Mounting Block
Set at 2 in. (5 cm)
Set Screw
Set at 2 in. (5 cm) using
this edge of block
Top View