Pg. 24
digits of the predialled number, in which case the prefix number will
replace the detect string digits.
You can enter up to 5 digits for the detect string and up to 10 digits for
the auto prefix number.
1. Press MENU key to enter menu selection.
2. Press the Navigation key to select ADVANCED SET and then press
OK key to select.
3. Press the Navigation key to select AUTO PREFIX and then press
OK key to select.
4. To enter a DETECT DIGIT string, press press OK key again.
The last stored detect string is displayed (if any).
Enter a detect string number (maximum 5 digits) and then press OK
key to confirm.
To enter a PREFIX number, press Navigation to display PREFIX and
then press OK key. The last stored prefix number is displayed (if any).
5. Enter the prefix number (maximum 10 digits) and then press OK key
to confirm. A confirmation beep is played.
** If no detect string (blank) is entered, the prefix number will be auto-
matically added to the predial number after TALK key is pressed.
For numbers starting with *, # or P, the prefix number will not be added
to the predial number after TALK key is pressed.
change recall time
You may need the R button to send a Recall signal (also called Flash
or Timed Break Recall) if you are connected to a PBX. You should
normally leave the Recall Time at its default setting of Short (100ms),
as this is the standard recall required in the telephone network, but it
can be changed to Medium (270ms) or Long (600ms) if your telephone
is connected to a PBX that requires a different recall time.
1. Press MENU key to enter menu selection.
2. Press the Navigation key to select ADVANCED SET and then press
OK key to select.
3. Press the Navigation key to select RECALL TIME and then press
OK key to select.
4. Press the Navigation key to select SHORT, MEDIUM or LONG and
then press OK key to confirm. A confirmation beep is played.
Change the dial mode (dual mode dialing version only)
You should normally leave the dialling mode at its default setting of
TONE (also called MF or DTMF).
However, you can change to PULSE if necessary.
