© Pan Acoustics GmbH
V 1.0
Page 11 of 22
Manual
Only accessories approved by Pan Acoustics may be mounted and used on the mounting plate with
M20 thread in order not to endanger the stability. When a spacer bar is used to mount a top, the device’s
centre of gravity changes. The loudspeaker must therefore be set up in a level position and must be protected
by suitable means against live loads that could cause the loudspeaker to tip, slide or fall over. The spacer bar
(article no. 802455) must not be used in the extracted position. If several devices are stacked on top
of each other, it must be ensured that the devices sit securely in the stacking recesses. The stacked
devices must be protected by suitable means against live loads.
Before connecting the device to the mains power supply, it must be ensured that the specifi cations
regarding voltage and frequency match the specifi cations on the device’s connector panel. The spec-
ifi cations can be found near the mains power connection.
10. Initial operation
10.1. Mains power connection
The number of devices per mains phase depends on the maximum possible current load of the
phase. The latter must not be exceeded. If the full output power of the device is needed, it is
strongly recommended to operate only one device per mains phase.
•
Only operate the device on mains power supplies with earth contact.
•
Damaged mains power cables or plugs must be replaced with a faultless mains power cable or plug.
•
It must be ensured that the mains power plug is always freely accessible to be able to disconnect the
device from the mains power supply in case of danger or malfunction.
Mains voltage range:
100 to 240 VAC, +50/60 Hz, max. 800 W.
The device is connected to the mains power
supply by means of a mains power cable with
IEC-60320 C14 plug.
