11
Before you begin ensure that the gas hose connector and electrical cord are plugged in correctly.
START UP
Press the ON / OFF Button once to start the heater and the operation light (green) will light up.
After a short delay the combustion light (red) will light up, this indicates proper ignition has been
achieved and the burner is on.
Set temperature and room temperature are displayed on the screen.
When the ON / OFF light is glowing green the heater can be switched on by pressing the Remote
Control button.
TURNING HEATER OFF
Press ON / OFF button. The ON light goes out. Then press the OFF button on Remote Controller.
After the heater is turned off the convection fan will continue to operate for up to 4 minutes. This is to
lower the temperatures inside the heater and is normal.
Please do not unplug the heater while the fan is still operating.
Important Information:
When using the heater for the first time or after long periods of disuse, ignition may not occur the first
time it is operated as there may be air within the pipes.
The unit may make noises after igniting or extinguishing the heater. This is due to expansion and
contraction of the heater components and is normal.
If the heater fails to light, repeat the procedure after first pressing the ON / OFF button to turn the unit off.
Do not start then stop immediately. This may cause the heater to overheat or the filter light to come on.
The economy operation will not function if the set temperature reaches a temperature in excess of the
room temperature.
For safety reasons the heater will automatically stop after 8 hours of continuous operation except when
the timers are used.
Operating Instructions