Paloma PH-28CDVSN, Engineering Handbook

Page: 24 / 68

- 24 -
B. Error code is displayed when the Power Button on remote control turns on.
1. Error Code [82] (Gas Type Control Data Failure) is displayed.
Pull out the power cord or
turn off the electric ON/OFF
Switch.
(Make 120 VAC off.)
Was the
proper High Altitude
Connector installed
and adjusted?
*1
NO
YES
* Attach it firmly to the main PC Board.
* Purchase the proper High Altitude Connector
and install & adjust it.
*1 Is it firmly attached?
Check for any disconnection
and/or damage on the High
Altitude Connector. (Visually)
When the
power turns on
does the Error Code
[82] still display?
YES
NO
The water heater seems to be normal.
Try to operate again.
Replace Burner Control Assy.
WARNING: When replacing High Altitude Connector,
always turn off the electric power to water heater.
2. Error Code [14] (Over Heating) is displayed.
Is the
Film Type OHL OK?
*2
Replace Burner Control Assy.
YES
NO
Replace Film Type OHL.
*2 Measure the resistance of connector .
Between both White wires: 50 ~ 500 k ohm
WARNING: If the Over Heat Limiter operated, check the reason
why and correct the problem.
Do you
have a proper High
Altitude Connector?
NO
Warning: When installing the High Altitude or Sea Level
Connector, follow the instruction of High Altitude or Sea Level
Connector.
A different High Altitude Connector is required for every 3,280
feet (1,000 m). The High Altitude Connector is not
interchangeable between Indoor, Outdoor and Direct Vent
models, Residential model or Commercial model, type of gas
or serial number. Check the number on the High Altitude or Sea
Level Connector. (Refer to the latest table of the Connector.)
Install & adjust the proper High Altitude
Connector according to the instruction.
Refer to Pages 38 ~ 41.
YES
U