6
FOLD 72 FIRE TABLE CE Electronic Ignition | Installation & Owner’s Manual
WARNING:
Failure to position parts in accordance
with these diagrams and instructions
and/or failure to use parts specifically
approved for use with this appliance may
result in property damage or personal
injury.
Do not remove the data plates attached
to the Outdoor Fire Pit Burner. These
plates contain important information.
NOTICE:
Installation and repair should be done by
a qualified service person. The appliance
should be inspected before use and at
least once annually by a qualified service
person. More frequent cleaning may be
required as necessary. It is imperative
that control compartment, burner ports
and circulating air passageways of the
appliance be kept clean.
CAUTION:
New Lava Rock may pop or crackle when
first heated. This should subside after 30
minutes to one hour or more of operation.
Maintain safe distance during this time.
ASSEMBLY
DECORATIVE
TOPPING
BURNER
MEDIA
IGNITION
PORT
TO ASSEMBLE THE FIRE PIT
1. Assemble fire pit housing per diagram on page 3.
2. Connect the Burner Assembly to the gas supply using the
supplied flex connector, following the instructions on p 9.
3. Carefully leak test all connections following the procedure
on p 9. Check the air shutter on venturi. For NG it is sealed.
For LP it is fully open (see part 2a, pg 14)
4. Fill the burner trough evenly with burner media (crushed
tempered glass for natural gas; volcanic rock for propane).
Do not obstruct the pilot ignition port with burner media! Do
not use media not supplied by Paloform!
5. Place the burner assembly on a stable surface. Ensure
burner is level.
6. Follow the Initial Lighting Instructions on page 10. Make
sure that the flame is even along the burner length and
appliance is fully operational and safe for use. Turn OFF the
appliance and let it cool before proceeding to the next step.
7. Carefully lift the burner and place it in the Robata body.
(See page 3)
8. Place and evenly distribute decorative topping media (lava
rock or tempered glass pebble) on top of burner media.
(See page 8). Decorative media should be brought level
with the top of the pilot cover. An uneven or excessively
thick layer of topping can result in an uneven flame.
Do not obstruct PILOT IGNITION PORT!
9. Correct flame appearance:
