4
ASSEMBLY (CONTINUED)
•
Attach the long and short braces to the legs.
•
Set stand upright on floor and tighten all bolts and nuts firmly.
INSTALL HANDLE
Refer to Figure 5.
•
Handle with knob is installed on the top right of the
planer/molder.
•
Insert handle with knob onto elevation screw top.
•
Secure handle with socket head bolt using wrench provided.
•
Insert plug into handle to cover bolt.
INSTALL DUST CHUTE
Refer to Figure 6.
•
Slide dust chute over fan housing. Secure in position with
screw.
•
Attach the Half Bag Dust Collection Set (included) only after
mounting planer/molder to stand.
MOUNT PLANER/MOLDER TO STAND
Refer to Figure 7.
•
Planer/molder is designed to be portable so it can be moved to
job site, but should be mounted to its included stand for stability.
•
Make sure stand is located on a firm, level surface in a place
with ample lighting and correct power supply.
•
Make sure there is plenty of room for moving the workpiece
through the entire cut. There must be enough room that nei-
ther the operators or the bystanders will have to stand in line
with the wood while using the tool.
•
Place the planer/molder on stand top.
CAUTION:
Planer/molder weighs approximately 150 lbs. Two peo-
ple may be required to lift planer/molder.
•
Position the planer/molder on stand top as shown in Figure 7.
Make sure that the four holes on the planer/molder base cast-
ing are aligned with four slots on stand top.
Palmgren Operating Manual & Parts List
84115
Figure 5 – Installing Handle
Figure 4 – Assembled Stand
Elevation Screw
Plug
Leg ‘A’
Short Brace
Long
Brace
Figure 6 – Installing Dust Chute
Figure 7 – Mounting Planer to Stand
Mounting Hole
