Palfinger V 1000 LQ, Fitting Instructions Manual

Page: 22 / 34

18
LOCATION OF LIGHTS
•
The vehicle rear lights should be
positioned to meet the lighting
regulations. The lights can be mounted
from the under-run bar if required.
•
If lights are to be mounted to the top of
the under run bar
– Special light “toe-
guard” brackets can be supplied by
PALFINGER TAIL LIFTS ltd. as an
option to prevent foot trapping (See
Figure 5)
Figure 5
•
The vehicle rear lights should be positioned to meet the lighting regulations.
•
The lights can be mounted from the under-run bar if required.
•
Fit th
e short “toeguards” supplied to the under-run bar below the lights to prevent foot
trapping.
You must ensure each bolt is positioned centrally through the dropper flange
(See Fig 4.)
Remove Transit Strut
Remove transit strut from between column tops.
Columns
If columns need to be cut down at the bottom. To compensate for a lower vehicle floor
height you must ensure that the chain links are shortened to prevent the runner wear pads
potentially dropping out of the bottom of the column.