Palax Power 100S
Translation
1-2017
29
7 MAINTENANCE OF THE MACHINE
NOTE!
Always stop the machine and disconnect it from the power source be-
fore performing any service measures.
NOTE !
To clean up the guide rails for the pusher, drive the Palax Optimi once a
day to its extreme position (55 cm) and after that, return it to the desired cutting
length.
7.1 Replacing the crosscut saw-blade, Fig. 22
1. Remove the attachment screws of the cover casing, a 13 mm wrench.
2. Swing the large cover casing to the back.
3. Unscrew the blade-nut using the special wrench delivered with the machine. Right-
hand thread, a 36 mm wrench
4. Lift up the crosscut saw-blade from its normal position.
5. Clean up the surfaces of the flanges thoroughly.
6. Lift the new blade into position.
7. Before installing the blade, make sure that the pin, which prevents the saw-blade
from rotating, is in place.
8. The gap between the guide blocks and the blade must not be less than 5 mm.
9. Fix the blade and its protective cover.
Fig. 22
