Palax KS50s
Translation
1-2012
29
To ensure that the small balls C stay properly in position during assembly of
the detent end B, apply a small amount of Vaseline to the holes in the side
of the detent end B. Ensure that the part A comes into the correct position,
as illustrated in the picture.
8.10 Basic settings of the splitting valve
The valve and linkage have been adjusted and test run at the factory.
The initial settings do not usually change so there is rarely any need for
readjustment.
If parts of the launch linkage have been dismantled and then reassembled,
they must be adjusted in connection with the reassembly.
NOTE!
During adjustment of the hydraulic valve, the following must
apply:
1. The splitting cylinder must be in the rear position.
2. The launch rod must be tightened.
3. The engine must be switched off
