41
Palax D410 Pro+
Translation
1-2020
Malfunctions and their remedy
Disturbance
Cause
Remedy
The saw-chain is heavy on
power and gets hot
1.
The chain is blunt
1. Sharpen or replace the chain
Oblique resulting surface
1.
The other side of the chain
is blunt, e.g. after sawing
through a nail
1.
Sharpen or replace the chain
Splitting is not operational
1.
Protective net open
1.
Close the protective net
Saw-bar does not come down
1. Protective net open
1. Close the protective net
Splitting cannot be launched
1.
Wrong adjustment of the
launch rod
1.
Adjust
The splitting motion starts then
stops
1.
The valve does not lock up
1.
Check the operation of the
detent end
2.
Check the adjustment of
the launch linkage
The cylinder is moving
erratically and jams
1.
Malfunction of valve
1.
Lubricate the detent end of
the valve
2.
Lubricate the spool shifter
The conveyor does not start up 1.
Scrapers frozen to the bed
2.
Pressure too low
3.
Debris between the flight
and the edge
1.
Lift the chain
2.
Raise the pressure, turn in
the relief valve about half
a round
3.
Remove the debris
The high-speed valves operates
only at one speed
1. Debris in the high-speed
valve
1. Open and clean the valve
