37
Palax D410 Pro+
Translation
1-2020
NOTE!
Stop the machine completely, and disconnect it from the power source before opening
the saw-bar cover!
NOTE!
The saw-chain is sharp: handle it with gloves.
1
Open the saw-bar cover as instructed in point 8.3.
2
Loosen the attachment nuts for the saw-bar (using a 13-mm wrench). Fig. 34 A.
3
Loosen the tightening screw for the saw-bar. Fig. 34 B.
4
Remove the attachment plate of the saw-bar.
5
Remove the saw-bar and the chain.
6
Put a new chain on the bar and the tip wheel and put the saw-bar in place.
7
Put the attachment plate in place and tighten it lightly.
8
After that, tighten the chain to a suitable tightness.
NOTE!
Re-tighten the chain after cutting a few logs because a new chain always stretches
slightly at the start.
NOTE!
If you process small-sized logs only, you can use a shorter saw-bar and chain on your
D410 machine. Take into account that then also the maximum diameter of the log that
can be sawn will decrease.
Figure 34
