pakedge
device&software inc. /
SW24-GBP
19
pakedge
device&software
inc.
| 1163 Triton Drive | Foster City | California | 94404 | USA | 650.385.8700
Page
19
of
73
System (continued)
Name: Type the Username to be used to log on to the switch.
Password: Type the password that will be used to log on to the switch.
Inactivity Timeout: Type the amount of time in seconds the system will wait before
logging out due to inactivity.
SNMP Enabled: Select the checkbox enable SNMP (Simple Network Management
Protocol).
SNMP Trap destination: Type the IP address for the SNMP Trap.
SNMP Read Community: Type a password for SNMP read-only access.
SNMP Write Community: Type a password for SNMP Read/Write access.
SNMP Trap Community: Type a password for SNMP Trap access.
To save your changes, click Apply.
3.1.2.
Port Configuration
To configure the network settings for individual ports, click Port Configuration in the navigation
menu.
Enable Jumbo Frames: Enable this function if you want larger frames sizes to be used. This
will allow data to be sent in fewer frames. However, make sure the receiving clients are
capable of receiving Jumbo Frames.
Intrusion Lock: This feature disables all ports when an Ethernet cable is disconnected to
prevent an intruder from disconnecting a cable and plugging a rogue device into the
network.