PairGain PG-Flex FRC-754 L4, Manual

Page: 13 / 18

363-754-104-01, Revision 01 Installation and Test
PG-Flex FRC-754 List 4 June 22, 1998 9
Verify Installation
After the PG-Flex system is powered up and HDSL communication is synchronized:
1 Verify that the front panel ACTIVE indicators are all OFF and the FAULT indicator is OFF (no calls are in
progress).
2 Test the loop start circuits, as follows:
• Place an outgoing call for each subscriber circuit provisioned, and verify that the ACTIVE LED tracks
the progress of the call (refer to
Table 1 on page 2 for front panel indications)
• Place an incoming call to each subscriber circuit provisioned, and verify that the ACTIVE LED tracks
the progress of the call (refer to
Table 1 on page 2 for front panel indications)
3 Test the ground start circuits, as follows:
• Place an outgoing call for each subscriber circuit provisioned, and verify that the ACTIVE LED tracks
the progress of the call (refer to
Table 1 on page 2 for front panel indications)
• Place an incoming call to each subscriber circuit provisioned, and verify that the ACTIVE LED tracks
the progress of the call (refer to
Table 1 on page 2 for front panel indications)