Painless 57002, Instructions Manual

Page: 21 / 62

17
Step 19: With the horn removed, you can now access the pass-
through on the firewall. This is your access point to route the
Switch Control wires into the interior. (Note: You may need to
push open the factory carpet using your finger)
Step 20: Next, secure the loose ends of the Switch Control wires with
a piece of masking tape . This step is necessary to insure ease
when feeding the wire through the firewall on Step 21. Failing to
tape the ends can cause the loose wires to catch on the internal
structure of the dash.
WARNING: MAKE SURE YOUR SYSTEM IS NOT CONNECTED TO THE
BATTERY! THESE WIRES ARE HOT WHEN THE TRAIL ROCKER HAS
POWER AND WILL SHORT THE SYSTEM OUT IF THEY TOUCH AS
SEEN IN THE IMAGES BELOW. AGAIN, DO NOT RECONNECT THE
BATTERY UNTIL INSTRUCTED.