The contents of these instructions are divided into major Sections, as follows:
1.0
Introduction
2.0
About These Instructions
3.0
Contents of Painless Wire Harness Kit
4.0
Tools Needed
5.0
Pre-Installation and General Harness Routing Guidelines
6.0
General Harness Installation Instructions
7.0
Mopar - Specific Circuit Connection Details
8.0
All Makes - Specific Circuit Connection Details
9.0
Wire Connection Index and Fuse Requirements
Sections are divided into subsections and Paragraphs. Throughout these instructions, the Figure numbers refer to
illustrations and the Table numbers refer to information in table form. These are located in Sections or Paragraphs
corresponding to the number. Always pay special and careful attention to any
Notes
, especially those in the Tables,
and any text marked
Caution
.
3.0
CONTENTS OF THE PAINLESS WIRE HARNESS KIT
Refer to Figure 3-1 to take inventory. See that you have everything you're supposed to have in this kit. If anything
is missing, contact the dealer where you obtained the kit or Painless Performance at (800) 423-9696. The Painless
Wire Harness Kit should contain the following items:
A
The Main Wire Harness, with the Fuse Block wired in and fuses installed.
B
Headlamp Connector Cables. (Extra Headlamp Cables are available separately under P/N 80300.)
C
Maxi Fuse
D
Firewall Grommet (large)
E
2 Fender Well Grommets (for Headlamps)
F
2 packages of Nylon Tie Wraps
G
Parts Box, containing Terminals, Splices, etc. This booklet, P/N 90542 Painless Wiring Manual.
Figure 3-1 Painless Wire Harness Kit
5
4.0
TOOLS NEEDED
