Table 10.1 Fuse Requirements
9.0
TESTING THE SYSTEM
9.0.1 Use a small battery charger (10 amp or less) to power up the vehicle for circuit
testing. If there is a problem anywhere, the batter charger’s low amperage and
internal circuit breaker will provide circuit protection.
CAUTION:
IF YOU HAVE NOT YET DISCONNECTED THE BATTERY FROM THE
AUTOMOBILE, DO SO NOW! DO NOT CONNECT THE BATTERY
CHARGER WITH THE BATTERY CONNECTED.
9.0.2
Connect the battery charger’s NEGATIVE output to the automobile chassis or
engine block and its POSITIVE output to the automobile’s positive battery
terminal.
9.0.3
INDIVIDUALLY turn on each light, ignition, wiper circuit, etc, and check for
proper operation.
9.0.4
After all circuits are checked out THEN attach the battery cable to the battery for
vehicle operation.
10.0 WIRE CONNECTION INDEX AND FUSE REQUIREMENTS
In each section, connect the wire, as identified by its wire color, to the appropriate item in the
CONNECT TO column. Pay close attention to the
NOTES
in this section. Indentified by small,
raised number such as the one at the end of this sentence.¹
Table 10.2 is divided into sections that correspond to the sections of your wire harness,
(ENGINE SECTION, DASH SECTION, TAIL SECTION, etc). The Index is divided vertically into six
columns: COLOR, GA. NUMBER, CONNECT TO, STARTING POINT, and SECTION OF STARTING
POINT.
The columns labeled “STARTING POINT” and “SECTION OF STARTING POINT” are for your
reference ONLY. The items in these columns tell you where each originates and from which
section of the harness.
The column “NO.” contains a 900-series number that is used to indentify various wires in the
wiring diagrams that are a part of these instructions.
Many (but not all) of the numbers occur TWICE in this index. That is because you will be
connecting BOTH ENDS of many of the particular wire segments. However, some wire segments
are pre-connected at one end. For instance all wires orginating from the fuse panel and certain
other wires such as those orginating from the horn relay, the dimmer swicth, and the instrument
panel section.
10.1 FUSE REQUIREMENTS
19
Headlight Switch
30
Emergency Flashers/Dome
25
Turn Signals
15
Gauges
15
AC/Heat
30
Horn
20
Wipers
15
Brake Switch
20
Electric Fan Relay
5
Coil
30
Radio Ignition (Switched)
10
Summary of Contents for 20110
Page 29: ...NOTES 24...
