4 9710 VCA
000216
Resistors
Solder each resistor in place following the parts placement
designators printed on the circuit board and the
assembly drawing fig 1. Note that resistors are nonpolarized
and may be mounted with either lead in either of the holes
in the board. Before mounting each resistor, bend its leads
so that they are at a right angle to the body of the part. Put
the leads through the holes and then push the resistor firmly
into place. Cinch the resistor in place by bending the leads
on the solder side of the board out to an angle of about
45 degrees. Solder both ends of each resistor in place
as you install it. Clip each lead flush with the solder joint
and save a few of the clippings for use in later steps.
A tip: If you can't find the location for a resistor, go on to the
next one and come back. DO NOT CHECK OFF A PART
UNTIL IT IS INSTALLED AND SOLDERED.
DESIGNATION VALUE COLOR CODE A-B-C
listed below: 100
brown-black-brown
( ) R28
( ) R33
( ) R40
( ) R44
listed below: 100k
brown-black-yellow
( ) R4
( ) R5
( ) R8
( ) R9
( ) R11
( ) R14
( ) R65
( ) R67
( ) R73
( ) R89
( ) R92
( ) R94
( ) R96
( ) R105
listed below: 10k
brown-black-orange
( )R12
( ) R13
( ) R21
( ) R50
( ) R64
( ) R66
( ) R91
( ) R93
( ) R95
( ) R100
( ) R102
( ) R104
( ) R108
( ) R118
( ) R38
10m
brown-black-blue
( ) R48
10m
brown-black-blue
listed below: 120k
brown-red-yellow
( ) R3
( ) R6
( ) R7
( ) R10
( ) R19
( ) R76
( ) R15
1500
brown-green-red
( ) R18
1500
brown-green-red
( ) R41
15k
brown-green-orange
( ) R42
15k
brown-green-orange
