1. Place the PackTite™ device on a
firm level surface that is free from
obstructions and at least 3 feet away
from any wall and from objects
such as furniture, curtains, plants or
combustible materials.
2. Unzip the zipper and remove the cord
and timer from wrappings. Extend the
cord out of the PackTite™ bag at the
back right corner of the flap.
3. Pull up the support bar on each end of
the support rack to an upright position
until the metal guides on either side
lock into place just on top of the
support rack.
4. When the flap is fully zipped, the cord
should extend out of the bag at the
right, rear zipper-end corner. Make
sure the timing unit is in the OFF
position before plugging the unit into
an electrical outlet.
ASSEMBLY INSTRUCTIONS
1. After assembling PackTite™, unzip the
top flap and place luggage (or personal
items) onto the support rack.
2. IMPORTANT – Do NOT place any
items on the terminal 2 inches on either
side of the rack. This is a ventilation
area and must be kept clear. Blocking
this vent area will cause a safety
shutdown and the unit will need to
be shipped to PackTite™ for repair AT
THE BUYER’S EXPENSE.
3. Make sure no part of the luggage or
any other materials dangle below the
support rack or come into contact with
the heating unit located under the
support rack.
4. Take care not to overfill the unit.
Luggage or other items should not
touch the outer sides of the PackTite™
the top flap, power cord or the zipper.
5. Unzip or open your luggage to enable
heat to disperse evenly into the interior
of your luggage and its contents. Also
unzip any exterior compartments on the
luggage.
6. Place the top support bar lengthwise
across the top of PackTite™ by laying
the ends over each support bar.
7. Zip up the flap and turn the electronic
timer to the 4-hour setting (a green
light will appear).
OPERATING INSTRUCTIONS
