Section 5
LABELING UNIT
-
10
-
English
F
412
0501
00.fm
ID
M
version:
Module 40/60/90/120
3 -Loosen the fixing screw on the
bottom flange.
4 -Manually shift the
winder disk
upwards or downwards, turning it to
facilitate this adjustment.
5 -Tighten the fixing
screw
on the
bottom
flange
.
Important
Spaces are cut in the bottom flange
to contain the spindle-fixing pins, so
that the flange can be moved right
down.
DEVIATION ROLLERS ADJUSTMENT
The diverter rollers are complete with
sliding rings to ensure the correct
positioning of the paper on the rollers.
Position the upper ring by hand so that
the top edge of the paper just comes
into contact with the ring.
Important
It is very important for all the bottom
rings to lie on the same level as the
unwinding device and winder disks,
which is typically 30 mm (or 38 mm)
from the top surface of the 80x80
support tubing, so that the paper
just comes into contact with the
rings.
BRAKE UNIT ADJUSTMENT
The height of the brake unit must be
adjusted by approximately centring it in
relation to the paper tape.
1 -Loosen the
knob
and set the
brake
at the height desired.
2 -When the brake has been set,
tighten the knob.
IDM-41200603500.tif
winder disk
flange
screw
IDM-41200600500.tif
IDM-01_014_0.tif
knob
brake
