ADF SERIES® OPERATION MANUAL
SECTION 5: UNPACKING AND INSTALLATION
Entire Contents Copyright
2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
ADF Series Power Source Operation Manual
Page 63 of 349
5.15
Cabinet Systems Installation
ADF Series® power sources above 15kVA output are available pre-installed and pre-wired in
a 19-inch cabinet. These cabinet systems include all internal AC input and AC output wiring.
Several options can be added to these ADF cabinet systems as well.
5.15.1
Standard Cabinet Sizes
All standard ADF cabinet systems feature the same depth and width but height may vary by
power level to accommodate more or less ADF units.
The following two sizes are offered:
•
18U
For power levels of 30kVA or 45kVA
•
28U
For power levels of 60kVA to 90kVA
•
36U
For power levels higher than 90kVA
Note that alternative cabinet sizes and power levels may be supported for special
requirements so this information applies to catalog models only.
Refer to cabinet dimension drawings shown below for the two available cabinet dimensions.
5.15.2
Tools Required
Installing AC Input and AC Output cable connections to the terminal blocks furnished with
ADF cabinet systems requires the use of a Phillips screwdriver to remove the rear panel
screen and some Allen (Hex) wrenches for the terminal blocks.
#2 x 6 Phillips Screw driver. Not included in ADF Cabinet ship kit.
Summary of Contents for ADF Series
Page 348: ......