4
Electrician Installation Manual
EM-E Ceiling Fan
1.
Do not
attempt to operate the fan (or optional light kit) with any wall control that is not
approved by Pacific International Fans for use with its fans. DO NOT use solid state
controllers. The use of unapproved controllers will void your warranty.
2.
Do not
mix blade sets from one fan to another as this may upset the balance of the fan. If
only one blade is damaged you are still required to replace with a new set.
STEP 3 (Fig. 3)
a) TIGHTEN THE GRUB SCREW
.
(This is important to ensure the fan will not
wobble and the weight of the fan is supported).
b)
Hang the ball joint into the hanger bracket.
Ensure the groove on the hanger bracket is
locked into the slot on the ball joint.
Assembling the fan
STEP 2 (Fig. 2)
a)
Drill a hole in the timber nogging for wiring.
b)
Use the two hex screws to secure the hanger
bracket onto the timber nogging. The timber nog-
ging should be supplied by the installing electri-
cian and must be supported between the two ceil-
ing joists as shown in the diagram above.
STEP 1 (Fig. 1)
PERFORM THIS STEP IF THE WIRES HAVE NOT
BEEN FED THROUGH THE DOWN ROD.
a)
Loosen the ball joint screw and remove the
ball joint pin to separate the down rod from the
ball joint.
b)
Feed wires from motor housing up and
through the down rod.
c)
Insert the down rod pin into the connection
collar and the down rod cotter pin (avoid pinch-
ing wires). Clip in the cotter pin key and secure
down rod with the other shorter down rod screw
provided.
d)
Slide on canopy cover and refit the ball joint.
If an extension rod needs to be installed
please go to page 11.
Hanger
Bracket
Down Rod
Fig. 2
Timber Nogging
Hex Head Screw
Hanger
Bracket
Fig. 3
Ball Joint
Canopy
Washer
Cotter Key
Down Rod
Screw
Connection Collar
Cotter Pin
Fig. 1
Reverse
Switch
Cover
