10
Electrician Installation Manual
EM-E Ceiling Fan
1.
Do not
attempt to operate the fan (or optional light kit) with any wall control that is not
approved by Pacific International Fans for use with its fans. DO NOT use solid state
controllers. The use of unapproved controllers will void your warranty.
2.
Do not
mix blade sets from one fan to another as this may upset the balance of the fan. If
only one blade is damaged you are still required to replace with a new set.
Attaching an accessory light kit — a standard accessory light kit
Light Wires
Base Plate
STEP 4 (Fig. 22)
a)
Feed wires from the motor housing lower rim
through the hole in the centre of the base plate .
b)
Attach the base plate to the motor.
Fig. 22
STEP 5 (Fig. 23)
a)
Feed wires through the thread of the upper
part of the light kit.
b)
Secure upper part of the light kit to the
motor housing by tightening the thread.
c)
Connect light wires to the terminal block in
the lower part of the light kit.
d)
Secure the lower part of the light kit to the
upper part of the light kit by the tightening the
light kit screws.
e)
Fit light globes in to the light kit.
(note: Only specified globes should be used).
Fig. 23
Thread
Screw
Light
Wires
Terminal
Block
Lower
Part of Light
Kit
Upper Part
of Light Kit
