SKU 95338
PAGE 15
for technical questions, please call 1-800-444-3353;
troubleshooting section at end of manual.
OPERAtIOn
Make sure the Power Switch is in the “Off” position. (See figure M.)
Attach the heavy duty hose to the Pressure Washer, using the Quick Connector
Set (3a).
(See figure g.)
Attach the Spray Wand (31c), Turbo Wand (30c), or Brush Wand and Adapter (28c,
35C) into the Water Gun (18a), and press and twist the Wand into the Extension
until the Wand locks in place.
(See figures E and f.)
nOtE:
The Pressure Washer will not pressurize if the Nozzle is not completely
assembled. It will not work properly with only part of the Wand installed.
Connect the High Pressure Hose (27c) to the Pressure Washer.
(See figure g.)
Make sure all connections are tight. Then, open the water supply valve
fully
. If
leaks occur, shut off water and retighten connections.
IMPORtAnt! Prior to
turning on the Pressure
Washer, connect the unit
to the water supply. turn
on the water, disengage
the safety, and squeeze
the trigger (21c) until wa-
ter flows out of the Wash
gun (18a).
This removes air
from the system and allows
the unit to properly perform.
failure to follow this step
can damage the Pump.
Test the cleaning capabilities
and the run before starting
your cleaning project, as
explained on page 17, #1. Turn the Power Switch to the “ON” position, it should il-
luminate.
The motor will briefly run when the switch is first turned on to build
up pressure
and then go to standby until the trigger is squeezed.
nOtE:
The Motor (7a) does not run continuously, but only when the Trigger is
squeezed.
If a humming noise persists while the motor is on standby, briefly
discharge the nozzle in a safe direction.
Point the Nozzle in a safe direction. Then, disengage the Safety and squeeze the
Trigger (21c). Switch the unit’s switch to the OFF position whenever the gun is not
in use.
(See figures I and M.)
Clean the area, following the tips contained in the
Operating Tips section.
When finished spraying, fully engage the Trigger Safety Lock (22c), turn the Power
Switch to its “OFF” position, and turn off the water supply.
(See figure M.)
1.
2.
3.
4.
5.
6.
.
8.
fIgURE M
(REAR VIEW)
POWER
