SKU 95338
PAGE 10
for technical questions, please call 1-800-444-3353;
troubleshooting section at end of manual.
ASSEMbly
nOtE:
For additional information regarding the parts discussed in the following pages,
refer to the
Assembly diagrams near the end of this manual
.
Check the Inlet Strainer for any blockage, including packaging debris. The Pres-
sure Washer may be shipped with a plastic plug in the Inlet.
HAndlE
(28A)
dEtERgEnt
PORt
(Hidden behind
Handle)
dEtERgEnt
tUbE (32A)
ScREW
(25A)
fIgURE d
REAR
VIEW
ScREW
(25A)
Position the rear of the Handle (28a) above the rear of the Pressure Washer body.
Insert the Valve located at the bottom of the Handle into the Suction Tube located
at the top of the Pressure Washer body. Make sure that the Suction tube does not
bend or get pinched during assembly. Lower the Handle fully onto the Pressure
Washer Body. Then secure the Handle to the Pressure Washer body, using the
Screws (25a) provided. (See Figure D.)
1.
2.
