27
060718-44
100000432-50
Optional Log Media Installation
1. Position rear log #1 at the back of the firebox on
top of the pilot sheild. (Figure 33)
2. Interlock right log #2 with rear log use the pin in
the burner tray to position the log (Figure 34) .
3. Lean left log 3 against log set engage the pins
in log #1 and the burner tray (Figure 35).
4. Interlock front log #4 with left log and use
the pin in the burner tray to position the log
(Figure 36).
Note: Do Not Block Pilot With Logs
Log Placement
The Driftwood log-set with pebbles requires that any crushed glass media be removed if it is present. The
pebbles are spread out around the perimeter of the burner basket after which the glowing embers are evenly
spread out inside of the burner basket - (Figure 33). The stove is delivered with two media dividers - a large
one for the Mirage 30 model (Figure 31), and a smaller one for the Mirage 18 model. The divider will be
placed into the center of the burner basket (Figure 32) and is used to separate the pebbles and glowing
embers.
Figure 31: Media divider.
Figure 32: Media divider in place.
Figure 33: Log 1.
Figure 34: Log 2.
Figure 35: Log 3.
Figure 36: Log 4.
Rocks
Embers
Note: Keep gap in media
divider (Figure 31) faced to the
rear of the burner basket, next
to the pilot assembly.
Note: It is not necessary to use the entire contents of the Embers bag and the Rocks
bag. Use enough to cover the burner tray with a single layer. Any more can interfere
with proper flame distribution.
Log Pin