21
Fig. # 21
Fig. # 22
Vent Restrictor
installed here if
required
BURNER REMOVAL
Caution:
Turn off gas and electrical power supply and allow ample
time for the unit to cool before proceeding.
The glass frame must be removed, if installed, to remove the burner
from the firebox. The glass frame is held in place by three over-center
latches located under the firebox along the front edge.
1) Fold down the front bottom louver, if installed, to access the over-
center window latches.
2) Disengage the over-center latches by pulling each lever down
and forward. Grasp the sides of the frame and swing the bottom
out to clear. Lift up and forward to disengage from the top. Place
the glass frame assembly in a safe place to avoid damage.
3) Carefully remove log set (note position if installed) and set aside,
taking care not to damage them. Remember, the logs are
extremely fragile! Remove ember material and save for reuse.
4) Disconnect gas supply line.
5) Remove the two wing nuts under the firebox which secure the
burner. Remove the entire assembly from the firebox by tilting it
slightly forward and lifting up and out (see Fig. #21).
Reassemble in reverse order, taking care to ensure that all gas
connections are sealed. Be sure to align the two studs on bottom of
burner with holes in base of the firebox.
OPTIONAL BRICK PANELS INSTALLATION
Decorative brick panels are to be installed after the burner is in place.
1) Unpack and inspect brick panels.
2) Place the back brick panel against the rear of the inside of the
firebox so that the largest row of bricks is on the bottom (see Fig.
#22).
3) Place the right side panel into the right side of the firebox, brick
side facing in.
4) Place the left side panel into the left side of the firebox, brick side
facing in.
f i r e - p a r t s . c o m