PACE Sodr-X-Tractor Handpiece
©2012 PACE Inc., Southern Pines, NC. All Rights Reserved
Page 3 of 11
www.paceworldwide.com
These instructions detail the basic operational guidelines for using the SX-80 & SX-90 Sodr-X-Tractor handpieces.
The SX-80 has yellow coloration on it and the SX-90 has blue coloration on it. The SX-80 is only available in
SensaTemp technology while the SX-90 is available in SensaTemp and Intelliheat technologies.
Introduction
The Sodr-X-Tractor handpiece provides thermally enhanced through-hole desoldering on extra heavy multilayer
assemblies, at safer, lower temperatures, even during continuous use. This Sodr-X-Tractor handpiece features a large
easy to replace solder trap, slim-line, pencil grip design and finger actuated vacuum switch facilitates ease of use and
manipulation in tight places. The Sodr-X-Tractor is a member of the PACE SensaTemp family of advanced handpieces.
CAUTION
Always return heated handpieces to the appropriate Tip & Tool Stand when not
in use. Failure to do so may cause burns to the operator, equipment or work
surfaces and may be a potential ignition source if combustible materials are
nearby. Always use this handpiece in a well-ventilated area to avoid inhalation
of fumes created by solder flux.
NOTE
Always use your Sodr-X-Tractor with a clean VisiFilter element. Otherwise
deterioration in performance or damage to the unit may occur.
Select and enter your desired true operating temperature on your PACE power
source. To save tip life and reduce the possibility of damage, PACE
recommends using the lowest possible tip temperature that will provide rapid yet
controllable melt of the entire solder joint to be extracted. Begin with an
operating temperature in the range of 316°C (600°F) and adjust as necessary.
