PACE Sodr-X-Tractor Handpiece
©2012 PACE Inc., Southern Pines, NC. All Rights Reserved
Page 8 of 11
www.paceworldwide.com
Tip Cleaning
During heavy, continuous desoldering, on boards with flux residues or other contamination, the tip may
occasionally become clogged with such material. If this should occur, clean the tip with the Tip Cleaning Kit
(PACE part number 6993-0200) by inserting the wire tool into the tip end.
Special Applications
If you require assistance in the use of this handpiece or with a special application, contact PACE Technical
Support at: 910-695-7223 Extension 1555
Replacing the Disposable Solder Collection Trap
As the Sodr-X-Tractor is used, solder and flux build-up will begin to impede the airflow and decrease system
performance. The SX-90 & SX-80 utilize a disposable chamber that makes maintenance a quick and simple
process. Regular replacement of the Sodr-Flux Trap will keep the Sodr-X-Tractor handpiece operating at peak
performance. To replace the Sodr-Flux Trap follow the procedures outlined below.
1. While holding the Sodr-X-Tractor with the tip facing
away from you and the handpiece in a downward
position, remove the door assembly from the
handpiece. This action is accomplished by pulling the
plunger lock approximately ¼”
and turning it
approximately ten (10) degrees to the right or left. The
door assembly can now be removed by simply gripping
the door near the ear shaped protrusions and lifting
straight up.
2. Replace the disposable chamber by holding the door assembly in
the palm of your hand with the filter
assembly facing up. With your free hand use a fresh solder chamber with the arrows facing away to push
the spent chamber out of the door assembly and into a waste receptacle. The fresh chamber is now in
position and ready for reassembly.
3. Complete the process by lowering the door into the handle assembly. Insure that the door is properly
situated with the ears seated in their respective detents. Now return the plunger assembly to its locked
position by simply twisting the plunger locks mechanism so that it returns to the channels in the handle
assembly.
4. Insure that the door assembly is securely in place by attempting to lift the door from the handle assembly. It
should now be held firmly in place.
5. Check all air hose fittings. Actuate the vacuum and insure that proper vacuum is present at the tip.
6. Return the handpiece to the cubby or resume work as required.
CAUTION
The handpiece will not function properly if the chamber is inserted incorrectly. The
directional arrows on the solder chamber must be pointed at the heater.
