©2022 PACE Inc., Vass, North Carolina, All Rights Reserved Page 3
https://paceworldwide.com/
System Set-Up
Set up the ST35 system by doing the following.
1. Remove the unit from its shipping container. Store the shipping container(s) in a convenient location.
Reuse of these containers will prevent damage if you ship or store the system.
2. Place the unit on a convenient workbench.
3. Ensure the POWER Switch (located on power source front panel) is in the "OFF" or "0" position.
4. Inspect all system components, check for shipping damage, and ensure that all purchased components
(standard and optional) are present.
5. Assemble Tip & Tool Stands. Attach to the power source if desired using included hardware. Assembly
instructions are enclosed with each Tip & Tool Stand.
Handpiece Connection
The ST35 is designed to work with the SensaTemp PS-90 Soldering Iron or any other of the SensaTemp hand
tools that do not need air pressure or vacuum to function.
Caution:
Using handpieces from other product lines
(e.g., IntelliHeat, AccuDrive, HeatWise) may result in damage to your new equipment.
Connect the handpiece connector to the Power Receptacle in the following manner.
1. Align guide on connector with slot on power receptacle.
2. Insert connector into power receptacle.
3. Turn the connector housing clockwise to lock in place.
System Power
1. Insert the female end of the power cord into the AC Power Receptacle on the rear panel of the power
source.
2. Plug the prong end (male end) of the power cord into an appropriate, grounded AC supply receptacle.
Setup and Operation
