52
MAKING USER SETTINGS (cont.)
1. If you have not done so, put the set-top into “user settings mode”, as described on page 41.
2. Press the
U
or
D
button on the remote control and highlight Restore Defaults in the PACE
USER SETTINGS menu.
3. Press the
R
button. The message: “Restore Default. Press OK to confirm” appears on the TV
screen.
4. To confirm and restore the factory settings, press the
SELECT
button.
The factory settings are restored, and the PACE USER SETTINGS menu reappears.
5. If you want to continue changing the settings, see the sections from page 41 onwards. If you have
finished changing the settings, press the
POWER
button. The set-top will switch on with the
restored settings.
NOTES
If the set-top and HDTV are connected via an HDMI
TM
cable, the HDTV may pass information about the
required settings back to the set-top (see page 43). If you wish to restore the set-top’s settings to those
created by the HDTV, you should disconnect the set-top from the HDTV before you restore the factory
default settings. When you reconnect the HDTV to the set-top via the HDMI
TM
cable, the HDTV will pass
back the information again.
Always turn off the set-top, wait 60 seconds, then disconnect the set-top from the wall AC
outlet before you connect or disconnect any other equipment to or from its rear panel.