System Operations Manual, Rev B
www.paceworldwide.com
Page 8 of 21
2. Insert connector into power receptacle.
3. Turn the connector housing clockwise to lock in place.
System Power Up
1. Insert the female end of the power cord into the AC Power
Receptacle on the rear panel of the power source.
2. Plug the prong end (male end) of the power cord into an appropriate 3 wire grounded AC
supply receptacle.
CAUTION:
To insure operator and ESD/EOS safety, the AC power supply receptacle must be
checked for proper grounding before initial operation.
NOTE:
Ensure that the system is placed in a well-ventilated area. Fume extraction equipment
is recommended
Tip Cartridge Installation
Tip cartridges are fitted with a key lock device. This feature ensures that tip
cartridges are held firmly in position and will maintain their orientation. To install a
tip cartridge, please follow the procedure below.
1. Line up the key lock feature on the tip cartridge with the notch on the front
of the handpiece. See Figure 8.
2. Push the tip cartridge all the way into the handpiece.
To remove a tip cartridge, use the included hot grip removal pad to grasp the tip
cartridge and pull the tip cartridge out of the handpiece. Be careful when completing this procedure
as the tip cartridge may be hot and direct contact can cause injury.
Tips cartridges can be changed at any time and without turning off the power to the unit.
Figure 7
Figure 8