System Operations Manual, Rev B
www.paceworldwide.com
Page 16 of 21
The ICA offset also allows for improvements to be made to the InstaCal Module without losing backwards
compatibility with all existing systems. All InstaCal modules are shipped with an ICA Offset value. When
the new InstaCal module in installed, the ICA offset value of the new module should be compared to the
value already stored in the system and modified if necessary.
To access the InstaCal Adjustment (ICA) offset follow the procedure below:
1. With the power turned off, press and hold the program button (
) and the up key (
▲
).
2. Turn on the power switch. The LED Display will show the software version (e.g. 1-2) then will
begin to flash between “ICA” and the entered ICA off set value.
NOTE: If a password has been entered into the system, the LED Display will first show
“EPO” and the password must be entered before access to the ICA offset is granted.
3. Using the up and down keys, adjust the ICA offset as needed.
4. Press the program key (
) to exit the ICA menu and resume normal operation.
PACE does not recommend modifying the ICA offset to compensate for tip geometries. Please use the
Cartridge OffSet (COS) value in the set-up menu to compensate for differences in tip geometries.
Available Tips/Accessories
A wide variety of tip cartridges are available for use with either the HW 100 or TW 100 systems. Please
refer to the table below for available tip cartridge styles.
PACE P/N Description
1124-0001-P1
1/32" Conical Sharp Extended
1124-0002-P1 1/64"
Conical
Sharp
1124-0003-P1
1/64" Conical Sharp Bent 30 Degrees
1124-0004-P1
1/64" Conical Sharp Extended
1124-0005-P1 1/32"
Conical
1124-0006-P1
3/128" Conical
1124-0007-P1
1/16" 90 Degree Chisel
1124-0008-P1
3/64" 30 Degree Chisel
1124-0009-P1
3/64" 30 Degree Bevel
1124-0010-P1 13/64"
Chisel
1124-0011-P1
1/64" 60 Degree Bevel
1124-0012-P1
1/32" 30 Degree Chisel
1124-0013-P1
3/32" 30 Degree Chisel
1124-0014-P1
5/64" 60 Degree Bevel
1124-0015-P1
1/64" Conical, Sharp, Bent 30 Degrees, Extended
1124-0016-P1
3/64" Chisel Bent 30 Degrees