Pace Technologies MEGA-T400S, Instruction Manual

Page: 25 / 30

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ▲
I
NSTRUCTION
M
ANUAL
MEGA - T400S
Abrasive Cutter
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1 - 520 - 882 - 6598 Fax +1 - 520 - 882 - 6599 email: pace@metallographic.com Web: https://www.metallographic.com
Please read this instruction manual carefully and follow all installation, operating and safety guidelines.
6.1 Trouble Shooting Error Codes
20
Error Code Code Description Solution
ERR 01 IPM error Disassemble and return to supplier
ERR 02 Over current Check the setting parameters
ERR 03 EEPROM error Rewrite the default value
ERR 04 Current sampling Rewrite parameters
ERR 05
(GF)
Bus under or over volt-
age
Check the voltage and parameters
ERR 06 Communication anomaly
Check the wire connection
ERR 07 Locate failed Check the encoder signal; Or the current feedback
wrong. Reposition and try again.
ERR 08 Lost step when running Normally, the reverse angle is 2 degrees, and the re-
verse angle is 20 degrees when positioning will be
wrong. Reposition and try again.
ERR 09 Overload Cutting too fast, too much load, or reduce the speed.
ERR 10 Module temperature is
too high
Check whether the fan works properly
ERR 12 Power failure Disassemble and return to supplier
ERR 13 Encode failure Check wire connection, or the encoder was damaged
ERR 14 Motor get stuck Check the motor or cutting speed is too high