Pace Technologies MEGA-T400A, Instruction Manual

Page: 29 / 36

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ▲
I
NSTRUCTION
M
ANUAL
MEGA - T400A
Abrasive Cutter
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1 - 520 - 882 - 6598 Fax +1 - 520 - 882 - 6599 email: pace@metallographic.com Web: https://www.metallographic.com
Please read this instruction manual carefully and follow all installation, operating and safety guidelines. 23
5.0 Maintenance
5.3 Instructions for Maintenance X - Axis
The recommended maintenance for the MEGA - T400A includes the following:
Important: Clean the table feed shaft after using the cutter to keep the abrasive from
building up in the bushing. If the table feed begins to become more difficult use WD
- 40 to
clean the feed shaft until the feed improves.
1. Clean periodically the bottom of the workbench to keep debris out of the X - Axis motor and
transmission.
2. Clean the top of the table base after a couple of cuts to avoid debris going into the X - Axis
screw.
3. Make sure to clean rails and guides to not over force the X - Axis motor.
4. Make sure nothing interferes with the X - Axis movement when is going back to origin to not
stuck the motor.
5. Clean the detection surface of the sensors from the top to avoid interferences. (Applies for both
axis Y/X)
In case of disassembly of the workbench follow these directions:
1. Make sure the M5 Hex screw that holds the X - Axis screw with the transmission is tight.
2. Align properly the transmission on the top plate.
3. Make sure the wiring in the bottom is not stressed and it ’ s covered properly (in case replace
the motor is needed)
4. Make sure the X - Axis bracket was properly installed on the bottom of the X - Axis plate and the
bolts are properly tightened.
Note: corrosion is considered a maintenance issue and not a warranty issue