Pace Technologies MEGA-T400A, Instruction Manual

Page: 27 / 36

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ▲
I
NSTRUCTION
M
ANUAL
MEGA - T400A
Abrasive Cutter
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1 - 520 - 882 - 6598 Fax +1 - 520 - 882 - 6599 email: pace@metallographic.com Web: https://www.metallographic.com
Please read this instruction manual carefully and follow all installation, operating and safety guidelines.
For proper clamping, use the appropriate clamping vises to securely hold the sample in
place. It is recommended that both sides of the part be clamped to avoid pinching of the
blade (possibly breaking the blade) and to minimize burning of the workpiece during
cutting.
For proper fixturing, take into account the initial stress on the samples.
!
4.6 Fixturing sample
4.6 Fixturing sample
Fast clamping
Left lever (Cat. No. QCL - 1100)
Right lever (Cat. No. QCR - 1100)
NOTE : vises have a slot in them so
that the face does not rotate
UNIVERSAL Clamping vise
UNIVERSAL (Cat. No. MG - 01)
Clamping height 0 - 3.5 in (0 - 90 mm)
MEGA Saddle
Clamping vise
MEGA
Fastener
Vise
22
For proper clamping, use the appropriate clamping vises to securely hold the sample in
place. It is recommended that both sides of the part be clamped to avoid pinching of the
blade (possibly breaking the blade) and to minimize burning of the workpiece during
cutting.
For proper fixturing, take into account the initial stress on the samples.
!